Rack And Pinion Gate Opener

Rack and Pinion Gate Opener (model GT1000DC) Instruction

170W motor power, the maximum bearing weight and length of the sliding gate are 800kg and 12m, with a DKC500DC-3 circuit control board. For this DC24V motor, you can connect the batteries and the solar panel to the control board, due to the transformer of 220V-24V/110V-24V in the gate opener, you can use 110V/220V power supply directly.

Add External Devices (must be completed by licensed electrician)

1. Infrared Sensor Photocells

Highly recommend the use of infrared photocells as an additional safety feature.

While closing, if the ray of the Infrared Photocell is blocked, the gate will stop and reverse

immediately, to protect user and property security.

The distance between photocell receiver and photocell transmitter should not be less than 2

meters; otherwise, the induction effect of photocell may be affected.

2. Storage Battery

3. Solar Panel Kit

Remote programming

The fourth button of the remote control is for pedestrian mode-while the gate is closed, if you press this button, the gate will open 1 meter wide to allow pedestrian access.

Learning

Remove motor outer cover and continue to remove the transparent PCB cover, press the

button ‘K4’ on the control board, until the ‘LEARN’ indicator light turns on, then release the

button. While the light is on, press the button intended to be paired on the remote control

twice, the ‘LEARN’ indicator light will flash repeatedly and then turn off when remote control

is paired. A maximum 40 remote controls can be paired to one motor.

Clearing

To delete all paired remote controls, press and hold the button ‘K4’ till LEARN LED turns on.

When the LEARN LED turns off, all previously paired remote controls will be delete.