What Are The Daily Fault Solutions For Garage Door Motor

Garage door motor is generally divided into middle type door machine and shaft drive door machine, the installation and maintenance of door machine should be carried out by professional technical personnel. In daily use are common problems and solutions in the following with a manual switch or remote control can't start the drive: driving device not connected to the power supply: check socket, plug, manual switch, fuse insurance tube manual switch or remote control receiver plate cut-off: check the manual switch and remote control receiver plate connection running too many lead to motor thermal protection: Reposition the travel switch to increase the travel door is not closed or opened completely: the position of the travel switch is not adjusted correctly: Reposition the travel switch to increase the travel the manual switch can control the drive device while the remote control can not: 1) Complete the code operation according to the instruction of the manual. 2) Replace the battery inside the remote control. 3) Please ask the maintenance personnel to check whether the receiving control panel door is not closed and automatically runs in reverse or stops running halfway without touching the travel switch when opening the door: Residual resistance is greater than the set the opening and closing doors to activate the obstacle induction system 1) away on-off device, check whether door and torsional spring balance, whether for opening and closing flexible 2) increasing the opening and closing carrying rod length adjustment improper, the connecting rod length regulation when the door closed door a one-way operation: stroke switch damage or stroke switch short circuit: Check the travel switch and travel switch wiring there are obstacles on the optical circuit of the photoelectric switch: clear the obstacles on the photoelectric shape optical circuit. The opening and closing load adjustment is not in place: re-adjust the opening and closing load force door body rushing through the travel switch: the travel switch is damaged or the travel switch line is open: Check the travel switch and travel switch connection distance of remote control outside the garage is significantly lower than 10 meters: garage shielding is serious 1) extend the antenna to the outside of the garage 2) extend the antenna outside the driver and straighten the battery power shortage: replace the electric gate body operation noise is too large: hardware installation is not solid: Solid hardware drive rod is not located on the centerline of the door body: the adjustable drive rod coincides with the centerline of the door body. The running guide rails of the door body are not parallel: the running guide rails of the regulating door body are parallel to each other and the hinge and the roller are not coated with lubricating oil: the lubricating oil driving device is running normally at the hinge and the roller, but the door body is not running: the clutch on the sliding frame is not reset: the opening and closing load adjustment of the reset clutch is not in place: Adjust the load of opening and closing to ensure your own safety, the above fault solutions should be handled under the guidance of professional personnel or directly solved by special personnel.