Gate Remote Control Receiver
If you need more than 100pcs remote controls be added, this RCV1 external receiver is a good choice, just connect this gate remote control receiver, easy to connect and there is a tape in the package, can be stick anywhere you want.
RCV1 Gate Remote Control Receiver Instruction
In normal, for GATEXPERT automation motors, the maximum quantity of the remote controls you can add to the control board is about 25pcs-100pcs, if you need more than 100pcs remote controls be added, this RCV1 external receiver is a good choice, just connect this gate remote control receiver, easy to connect and there is a tape in the package, can be stick anywhere you want.
The radio receivers are intended for remote control of the doors automation. The receivers can control one (single-channel), two ( two-channel), three ( three-channel) or four (four-channel) devices. The presented external radio receivers series are compatible with remote-control boards of the radio control system AN-Motors.
When receiving the command from the board the output of the receiver is activated (is closed) for 2 seconds.
Technical characteristics
Quantity of control channels | 1st 2nd 3rd 4th |
Operating supply voltage | 9B …35B DC / 8B … 26B AC |
Current consumption (not more than) | 30MA– standby mode / 70MA– output activation |
Operating frequency | 433.92MHz |
Quantity of receivable control boards | up to 500 pieces |
Relay output | NO (normally-open) |
Load of relay output contact | 1A max., 24Ǫ DC / 0,5A max., 125B AC |
Case protection rating | IP40 |
Environment temperature | -20℃… +50℃ |
Overall dimensions (not more than) | 78mm × 44mm × 25mm |
Length of connection cables (not less than) | 450mm |
Weight (not more than) | 80g |
How to program the gate remote control receiver?
1. Stick it on the place you need.
2. Connect the gate remote control receiver to the control board of the gate opener.
3. You can add 500pcs remote transmitters as you need.
Send Inquiry
