800N Automation For Garage Doors
PD800 800N automation for garage doors is applied to the garage door within 10 square meters and 80 kilograms, built in courtesy led light, with the function of soft start slow stop, the backup batteries and tracks available, C mode and T mode rails can be chosen.
800N Automation for Garage Doors Instruction
PD800 800N automation for garage doors is applied to the garage door within 10 square meters and 80 kilograms, built in courtesy led light, with the function of soft start slow stop, the backup batteries and tracks available, C mode and T mode rails can be chosen.
Technical Parameters
Unit Model | PD800 |
Power Supply | AC110V/60Hz;AC220V/50Hz |
Output Torque | 800N |
Max.Door Area | 10m³ |
Max.Door Weight | 80KG |
Limit Switch | Electronic Limit Switch |
Opening/Closing Speed | 160mm/Second |
Drive Mechanism | Chain/Belt |
Remote Frequency | 433.92MHz |
Working Temperature | -40°C～+50°C |
LED | 24V/15pcs LED bulbs |
Product Recommendation
1. Garage door must be able to be lifted and closed easily by hand and without much effort. A well balanced & sprung door is critical for proper installation.
2. The garage door opener can’t compensate for a badly installed garage door and should not be used as a solution for a “hard to open” door.
3. If the unit is being installed on an existing door, make sure any existing locking devices are removed or warranty will be void.
4. An approved outlet must be installed near where the opener is begin installed.
5. There should be a minimum gap of 30mm between the bottom of the chain drive rail and the top of the garage door at its closest point. (refer to Fig 1 of user manual.)
Important note: As for additional safety rules, we strongly recommends the fitting of Photo Electric safety beams on all installations.
Send Inquiry
