Sliding Gate Opener Sensor

IR11 Sliding Gate Opener Sensor Instruction

For this kind of infrared photocell sensor , you needn’t connect wires between transmitter and receiver of sliding gate opener sensor, more convenient for customer to connecting, because there is with 2pcs batteries in the package, it can get power from the batteries.

Technical Specification

Safety Instruction

1. For security, please read the user manual carefully before initial operation;

2. This photocell is without any fuse, so please make sure the power is off before installation;

3. Only used this system that do not cause any danger life or property during the running failure or its security risks eliminated;

4. Please guarantee the products used in effective working range.

Installation

1. The photocells should be installed more than 20cm above the ground ( to avoid reflection),and the distance between emitter and receiver shall be more than 50cm.

2. End user should install the photocell on the back of the direct sunlight or other strong light source (+5°) to keep photocell work well steadily.

3. Avoid installing other infrared photocell emitters within the effective distance of receiver.

4. If the end user needs to install other photocell in the one same straight line, the receivers

could be installed in the two end and the emitters could be back-to-back installed.

5. Stable installation could avoid the signal of emitter and receiver skewing due to lightly

vibrate and the malfunction.