Gate Opener DKC500DC Controller
Work for DKC500DC(L) and DKC800DC(L) sliding gate openers,the control board is 24VDC, compatible with 24V DC sliding motors, there are 8 dip switch to adjust.
Wiring instruction:
J1 Terminal
5 COM (GND)
6 Photocell input (N.C.);
7 Extra power input +24VDC
J2 Terminal
Connect to 24VAC（Fig.11 shows 120W 230VAC/24VAC annular transformer connection）
BAT+ Terminal
Battery interface
J4 Terminal
DC motor wire connection (Red wire to top, black wire to bottom)
J7 Terminal
1 Gate open control button (N.O.);
2 Gate close control button (N.O.);
3 Stop control button (N.O.);
4 Control button common terminal;
J8 Terminal
24V DC caution light
J10 Terminal
OP Open limit switch;
COM Limit switch common terminal;
CL Close limit switch;
DIP SWITCH
Work for DKC500DC(L) and DKC800DC(L) sliding gate openers,the control board is 24VDC, compatible with 24V DC sliding motors, there are 8 dip switch to adjust.
serial number | |
1 2 | 1 ON 2 OFF: automatic close delay time is 3s. 1 OFF 2 ON: automatic close delay time is 10s. 1 ON 2 ON: automatic close delay time is 30s. 1 OFF 2 OFF: cancel automatic close function. |
3 | ON - Remote control is three button mode, the first button is OPEN, the second button is CLOSE, the third button is STOP. |
| OFF- Remote control is single button mode, one same button on the remote control to circularly control OPEN/STOP/CLOSE/STOP. | |
4 | OFF - External button switch is single button mode, connect to 1 and 4 of J7. |
| ON - External button switch is three button mode. | |
5
| Left and Right installation setting. OFF - Right side mounting ON - Left side mounting The change of door close direction will be valid only after the re-power. |
6 | Limit switch setting. ON - Normal open (N.O.); OFF - Normal close (N.C.). |
7 | Meet obstacle reversal function. ON - enabled; OFF - disabled. |
8 | Infrared detection delay when closing ON - infrared detection delay is 1 second; OFF - infrared detection delay function is disabled. |
Send Inquiry
