DC Motor Circuit Board

Safety Instruction

Please read this manual carefully before installation, in which involves with important information about installation、using、maintenance and safety.

Any undefined operations under this manual is not allowed, incorrect using may damage the product even causing the injuries or property losses.

To consider the possible danger during the installation or using process of sliding gate opener, installation must strictly comply with the construction standard and electrical operating procedure, especially the following:

l Before installation, please make sure that the power voltage being used matches with the supply voltage of this product. Please check if the leakage protection switch is installed and the grounding system is correct.

l Please check if additional equipments or materials are required to meet the specific requirements.

l The disposal of packaging material must comply with the local regulation.

l Please do not change any parts except for those defined under this manual. Any undefined changes may cause the malfunction. Any damages to the product arising therefrom shall be beyond the liability of the company.

l Please do not leak water or any liquid into the controller or any other open devices. Please disconnect the power immediately if any mentioned cases happened.

l Please keep this product away from heat and open fire. Or it may damage the components; cause the failure or other hazards.

l Please make sure there is no vehicles、passengers or objects passing through while the sliding gate is moving.

l Anti-clip equipment like infrared protection switch must be installed to avoid injuries to person and property losses. The company shall not be liable for any damage or accident arising therefrom.

l The installation、using and maintenance of this product must be carried out by professionals.

l Children are not allowed be touch the control devices or play with remote controls.

l A warning sign must be placed somewhere on the sliding gate according to the national standard.

l Please keep this instruction properly for future reference.

1.6.2 Start-up Delay Setting (L3)

The control board for this product is with low power consumption function under standby mode. When the machine is stopped, the control board will automatically enter into low power consumption standby mode. Meanwhile, in order to reduce the power consumption of external accessories under standby mode, the control board will turn off the power for infrared sensor after entering into standby mode. When the machine is about to operate, it’ll supply the power for accessories. In order to ensure the reliability of the infrared sensor, it is requested that the control board performs delay detection to the input signal of infrared sensor. When the gate opener receives the opening/closing signal, it’ll start to work after a certain time (the settled delay time)

A. Operation Instruction:

1. Press and hold “PROG” button for 3 sec. to enter into basic menu. à Indicator light L0 will flicker once, then L1 will be always on.

2. Press “PROG” button again for 3 sec. to enter into advance menu. à L0 will flicker twice, then L1 will be always on.

3. Press “+” button twice, choose start-up delay setting. à Indicator light L3 will be always on.

4. Press “SET” button once to enter into acceleration setting. à Indicator lights L1-L3 will show the current setting. (The default is L1)

5. Press “+” or “-” button to set the start-up delay time. à Indicator lights L1-L3 will show the current setting. (Table 3 Start-up Delay Time)

6. Press “SET” button once to save and automatically exit. à Indicator lights L1-L5 will be on for 1 sec.